Single Beam EOT Cranes

About Single Beam EOT Cranes

Single Beam EOT CranesWe have carved a niche for ourselves in the field of manufacturing, supplying and exporting efficient and easy to handle Single Beam EOT Cranes. Our range of Single Girder EOT Crane is very suitable for carrying up to 10tonne of load to 20 meters span and class-II duty. The crane is made of standard or box type plate beam, wheels, gearboxes, motors and running overhead to lift heavy loads and run in both directions. Our single girder EOT Cranes are designed and manufactured as per IS: 807 and IS: 3177. Standard Features of Single Girder EOT Crane: Simple and optimum design ensuring minimum dead weight: Wheel Load Headroom: Easy to maintain: Easy to install: Reliable structure: Available in Pendent Control Type and Radio Remote Control Type: Single and double speed type: Safe and reliable hoisting and traveling: Higher efficiency to save power: Cheap: Fail safe type brakes (which are applied when power supply is off and released when power supply is on.): All motion are protected with limit switches: Rubber buffers are provided as extra protection against collision in case of limit switch failure: Dustproof panel box with reputed make switch gear: 110 V control voltage selected for protection of crane operator against any electrical shock: With electrical interlocking to prevent simultaneous operation of opposite motion: Available in Class-I, Class-II, Class-III, and Class-IV, DutyUses: Wide application in heavy constructions all overManufacturing Range: 1t. to 10t. Cap., up to 20 meters span and required Height of liftSpecifications: Equipments: Single Girder EOT CraneCapacity: Available in 1ton, 2ton, 3ton, 5ton, 7.5ton & 10 tonSpan: Up to 20 metersTest Load: 125% of SWLHeight of Lift: Standard 6 meters (also available as per customers requirements)Duty & Class: Available in Class-II, Class-III, & Class-IV light , medium and heavy dutyIS Code: IS 807, IS : 3177Construction of crane: End Carriages: The End Carriages are welded construction type and fabricated from plates 7 Standard Section type constructionsPlatform: M.S. Checkered plate/anti skid two small platform shall be provided one side of the bridge girder.Steel: Steel confirming to IS-2062 or equivalent is used in the manufacturing of the main load bearing.Ele. Motors: Manufactured as per IS 325 for crane & Hoist duty of reputed make S-4 duty, Squirrel cage or slipring type motor, 40% CDF, 150 S/hr., IP 55 with Class F insulation.Wire rope: The make of wire rope will be used Usha-martin and selected as per 4 to 6 time factor of safetyBearings: All moving parts of the crane are supported on the anti friction type ball/roller bearings. (all bearings are SKF/ZKL/ or equal ant make)Supply Voltage: 415, 3ph., 50hz., Supply.Control Voltage: 110V.Switch Gears: BCH, L&T, Siemens, TC or your approved equivalent Contactors, switches are providing in Ele. PanelPush Button: Pendent type with hanging chain or wire ropeEle. Cables: Flexible Copper Cable with ISI mark or reputed makeLimit switches: two numbers rush roller type limit switch of reputed make is provided to prevent over lowering & over hoistingPainting: The structural parts of the crane are thoroughly cleaned and applied with two coats of red oxide and two coats of enamel paints before dispatch.